How-To: Daytona Pinlock Lens and Shield Installation
These short videos from Daytona Helmets show how to fit an anti-fog lens and how to change the shield on Daytona helmets. You can watch them right here in our store.
Installing a Pinlock anti-fog lens
- Take the shield off the helmet and lay it on a soft, clean cloth.
- Hold the lens by its edges, with the soft seal facing the inside of the shield.
- Flex the lens gently and set each end under the pin on that side of the shield.
- Check that the seal touches the shield all the way around. If there is a gap, take the lens out, turn the pins slightly and fit it again.
- Put the shield back on the helmet.